www.eleafworld.com is the ONLY official website of Eleaf as well as the ONLY site to verify the authenticity of the product purchased.
This site is intended for sale to adults 18 years or older. If you are not legally able to purchase tobacco products in the state where you live, please do not enter this site.
UNDER 18
18+(ENTER SITE)
Age Certification

iStick Power

iStick Power
iStick Power (5000mAh)
Product Introduction:
The iStick Power comes with an ultra-large battery capacity of 5000mAh in a compact design, which can last you for a remarkably long time at any power setting. Not only does it apply the new firmware with Smart mode and custom logo, the iStick Power also has a fashionable looking and comes with many attractive colors for your options.
iStick Pico Mega Kit
iStick Power
Parameter:
Size: 49.5mm*23.5mm*83.5mm
Thread type: 510 thread
Output mode: VW/Bypass/Smart/TC(Ni,Ti,SS,TCR-M1,M2,M3) mode
Output wattage: 1-80W
Resistance range: 0.05-1.5ohm (TC modes)
0.1-3.5ohm (VW/Bypass/Smart mode)
Temperature range: 100-315℃/200-600℉ (TC modes)
Color: brushed silver, white, grey, bronze, wood grain
Standard configuration:
1×iStick Power 1×USB Cable 1×User Manual
iStick Power
Long Sustainable Battery Life
The iStick Power comes in a compact design with an ultra-large battery capacity of 5000mAh. iStick Power
The Latest Firmware
It applies the latest firmware which features new VW interface, Smart mode and custom logo.
iStick Power
Various Modes with 80W Output
The iStick Power allows an intelligent but yet satisfying draw with 80W maximum output and provides you with different
vaping experiences with switchable VW/Bypass/Smart/TC(Ni,Ti,SS,TCR) modes.
iStick Power
Dual Circuit Protection
The circuit protection system has both software and hardware battery protections of
over-charging, over-current and over-discharging.
iStick Power
iStick Power
510 Spring Connector
It also retains stainless steel spring loaded 510 connector for strong wear resistance and high adaptability.
Functions of Micro USB Port
Charging: the iStick Power can be charged through USB port at the bottom
of the device via 1A wall adapter or a computer.
Firmware upgrading: the firmware can be upgraded by connecting the device with a computer through the USB port via a micro USB cable.
iPower
Download the file below to put custom logo in iStick Power.
iPower
iPower
Newly Added Reset Function
The iStick Power can be reset by keeping holding the up button and reset button simultaneously in case it could not be powered on after upgraded